Re: [PATCH v8 2/2] arm64: dts: qcom: add SA8540P ride(Qdrive-3)

[Johan Hovold]

On Wed, Nov 16, 2022 at 01:22:07PM +0530, Parikshit Pareek wrote:
> Introduce the Qualcomm SA8540P ride automotive platform, also known as
> Qdrive-3 development board.
> 
> This initial contribution supports SMP, CPUFreq, cluster idle, UFS, RPMh
> regulators, debug UART, PMICs, remoteprocs and USB.
> 
> The SA8540P ride contains four PM8450 PMICs. A separate DTSI file has
> been created for PMIC, so that it can be used for future SA8540P based
> boards.
> 
> Signed-off-by: Parikshit Pareek <quic_ppareek@xxxxxxxxxxx>
> Tested-by: Brian Masney <bmasney@xxxxxxxxxx>
> Reviewed-by: Brian Masney <bmasney@xxxxxxxxxx>
> Tested-by: Eric Chanudet <echanude@xxxxxxxxxx>
> Reviewed-by: Eric Chanudet <echanude@xxxxxxxxxx>
> ---
>  arch/arm64/boot/dts/qcom/Makefile         |   1 +
>  arch/arm64/boot/dts/qcom/pm8450a.dtsi     |  77 ++++++++
>  arch/arm64/boot/dts/qcom/sa8540p-ride.dts | 221 ++++++++++++++++++++++
>  3 files changed, 299 insertions(+)
>  create mode 100644 arch/arm64/boot/dts/qcom/pm8450a.dtsi
>  create mode 100644 arch/arm64/boot/dts/qcom/sa8540p-ride.dts
> 
> +&apps_rsc {
> +	regulators-0 {
> +		compatible = "qcom,pm8150-rpmh-regulators";
> +		qcom,pmic-id = "a";

> +		vreg_l6c: ldo6 {
> +			regulator-name = "vreg_l6c";
> +			regulator-min-microvolt = <1200000>;
> +			regulator-max-microvolt = <1200000>;
> +			regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>;
> +			regulator-allowed-modes =
> +			    <RPMH_REGULATOR_MODE_LPM
> +			     RPMH_REGULATOR_MODE_HPM>;

The indentation here is off, but I noticed that you've probably just
copied that from the existing devicetree sources. I just sent a couple
of patches to clean that up:

	https://lore.kernel.org/lkml/20221116102054.4673-1-johan+linaro@xxxxxxxxxx/

You can drop the first newline and indent the continuation line properly
using tabs (and spaces).

> +			regulator-allow-set-load;
> +		};

> +		vreg_l17c: ldo17 {
> +			regulator-name = "vreg_l17c";
> +			regulator-min-microvolt = <2504000>;
> +			regulator-max-microvolt = <2504000>;
> +			regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>;
> +			regulator-allowed-modes =
> +			    <RPMH_REGULATOR_MODE_LPM
> +			     RPMH_REGULATOR_MODE_HPM>;

Here too.

> +			regulator-allow-set-load;
> +		};
> +	};

Johan