Re: [PATCH v4 01/12] dt-bindings: iio: qcom: adc7-pm8350: Allow specifying SID for channels

[Krzysztof Kozlowski]

On 03/11/2022 10:57, Manivannan Sadhasivam wrote:
> As per the new ADC7 architecture used by the Qualcomm PMICs, each PMIC
> has the static Slave ID (SID) assigned by default. The primary PMIC
> PMK8350 is responsible for collecting the temperature/voltage data from
> the slave PMICs and exposing them via it's registers.
> 
> For getting the measurements from the slave PMICs, PMK8350 uses the
> channel ID encoded with the SID of the relevant PMIC. So far, the
> dt-binding for the slave PMIC PM8350 assumed that there will be only
> one PM8350 in a system. So it harcoded SID 1 with channel IDs.
> 
> But this got changed in platforms such as Lenovo X13s where there are a
> couple of PM8350 PMICs available. So to address multiple PM8350s, change
> the binding to accept the SID specified by the user and use it for
> encoding the channel ID.
> 
> It should be noted that, even though the SID is static it is not
> globally unique. Only the primary PMIC has the unique SID id 0.
> 
> Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@xxxxxxxxxx>
> Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx>
> Acked-by: Rob Herring <robh@xxxxxxxxxx>
> Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@xxxxxxxxxx>
> ---

This was never sent to IIO maintainers, so now next is failing.

Please use scripts/get_maintainers.pl to get a list of necessary people
and lists to CC.  It might happen, that command when run on an older
kernel, gives you outdated entries.  Therefore please be sure you base
your patches on recent Linux kernel.

Best regards,
Krzysztof