Re: [PATCH 03/10] arm64: dts: qcom: Add pm8010 pmic dtsi

[Krzysztof Kozlowski]

On 16/11/2022 11:31, Abel Vesa wrote:
> From: Neil Armstrong <neil.armstrong@xxxxxxxxxx>
> 
> Add nodes for pm8010 in separate dtsi file.
> 
> Signed-off-by: Neil Armstrong <neil.armstrong@xxxxxxxxxx>
> ---
>  arch/arm64/boot/dts/qcom/pm8010.dtsi | 84 ++++++++++++++++++++++++++++
>  1 file changed, 84 insertions(+)
>  create mode 100644 arch/arm64/boot/dts/qcom/pm8010.dtsi
> 
> diff --git a/arch/arm64/boot/dts/qcom/pm8010.dtsi b/arch/arm64/boot/dts/qcom/pm8010.dtsi
> new file mode 100644
> index 000000000000..0ea641e12209
> --- /dev/null
> +++ b/arch/arm64/boot/dts/qcom/pm8010.dtsi
> @@ -0,0 +1,84 @@
> +// SPDX-License-Identifier: BSD-3-Clause

Any reason why this is licensed BSD-3 clause? It's not a recommended
license (2 clause is). Same for other patches.

> +/*
> + * Copyright (c) 2022, Linaro Limited
> + */
> +
> +#include <dt-bindings/interrupt-controller/irq.h>
> +#include <dt-bindings/spmi/spmi.h>
> +
> +/ {
> +	thermal-zones {
> +		pm8010-m-thermal {
> +			polling-delay-passive = <100>;
> +			polling-delay = <0>;
> +
> +			thermal-sensors = <&pm8010_m_temp_alarm>;
> +
> +			trips {
> +				trip0 {
> +					temperature = <95000>;
> +					hysteresis = <0>;
> +					type = "passive";
> +				};
> +
> +				trip1 {
> +					temperature = <115000>;
> +					hysteresis = <0>;
> +					type = "hot";
> +				};
> +			};
> +		};
> +
> +		pm8010-n-thermal {
> +			polling-delay-passive = <100>;
> +			polling-delay = <0>;
> +
> +			thermal-sensors = <&pm8010_n_temp_alarm>;
> +
> +			trips {
> +				trip0 {
> +					temperature = <95000>;
> +					hysteresis = <0>;
> +					type = "passive";
> +				};
> +
> +				trip1 {
> +					temperature = <115000>;
> +					hysteresis = <0>;
> +					type = "hot";
> +				};
> +			};
> +		};
> +	};
> +};
> +
> +

Just one blank line.


Best regards,
Krzysztof