Re: [PATCH] phy: aquantia: Configure SERDES mode by default

[Andrew Lunn]

> Well, part of my goal in sending out this patch is to get some feedback
> on the right thing to do here. As I see it, there are three ways of
> configuring this phy:
> 
> - Always rate adapt to whatever the initial phy interface mode is
> - Switch phy interfaces depending on the link speed
> - Do whatever the firmware sets up

My understanding of the aQuantia firmware is that it is split into two
parts. The first is the actual firmware that runs on the PHY. The
second is provisioning, which seems to be a bunch of instructions to
put value X in register Y. It seems like aQuantia, now Marvell, give
different provisioning to different customers.

What this means is, you cannot really trust any register contains what
you want, that your devices does the same as somebody elses' device in
its reset state.

So i would say, "Do whatever the firmware sets up" is the worst
choice. Assume nothing, set every register which is important to the
correct value.

	Andrew