[PATCH v2 2/3] irqchip/riscv-intc: remove user selectability of RISCV_INTC

[Conor Dooley]

From: Conor Dooley <conor.dooley@xxxxxxxxxxxxx>

Since commit e71ee06e3ca3 ("RISC-V: Force select RISCV_INTC for
CONFIG_RISCV") the driver has been enabled at the arch level - and is
mandatory anyway. There's no point exposing this as a choice to users,
so stop bothering.

Signed-off-by: Conor Dooley <conor.dooley@xxxxxxxxxxxxx>
---
I'd swear I had an interaction with someone a few months ago about the
RISCV_INTC Kconfig options but I cannot for the file of me remember who.
I hope this patch is not be going back on what I said then...
---
 drivers/irqchip/Kconfig | 11 +----------
 1 file changed, 1 insertion(+), 10 deletions(-)

diff --git a/drivers/irqchip/Kconfig b/drivers/irqchip/Kconfig
index ecb3e3119d2e..4633a549ebbf 100644
--- a/drivers/irqchip/Kconfig
+++ b/drivers/irqchip/Kconfig
@@ -538,17 +538,8 @@ config TI_PRUSS_INTC
 	  different processors within the SoC.
 
 config RISCV_INTC
-	bool "RISC-V Local Interrupt Controller"
+	bool
 	depends on RISCV
-	default y
-	help
-	   This enables support for the per-HART local interrupt controller
-	   found in standard RISC-V systems.  The per-HART local interrupt
-	   controller handles timer interrupts, software interrupts, and
-	   hardware interrupts. Without a per-HART local interrupt controller,
-	   a RISC-V system will be unable to handle any interrupts.
-
-	   If you don't know what to do here, say Y.
 
 config SIFIVE_PLIC
 	bool
-- 
2.37.2